| Info |
|---|
The configuration of the boot loader is bootloader and BIOS are standardized for all appliances. We take care of of the correct configuration during the before delivery of the appliance. |
| Status | ||||
|---|---|---|---|---|
|
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
|
In general, there is no need to change the bootloader or BIOS settings
...
as a customer.
...
We add password protection to ensure your appliances' bootloader and BIOS settings are
...
not changed by an unauthorized individual.
| Tip |
|---|
| The password of the iDrac is random and can be configured in the Webconf: Management interface configuration |
| Table of Contents |
|---|
There are two ways to reset the password
...
Problem
You lost access to the Webconf and the physical console because you lost the device password.
Solution
| Warning |
|---|
This will reset your appliance to factory defaults, and you will lose all data! Make sure to have working backups of the appliance and the Checkmk sites before attempting this! |
If you understand the warning above, you can reset your appliance by following the steps below:
Virtual Appliance
- Remove the virtual data volume (this is the 100 GB disk by default)
- Attach a new virtual drive with the same size as the old one
- Start the appliance
- The appliance will be reinitialized and back to the delivery state
- Configure your appliance from scratch and restore backups if necessary
Physical Appliance
- Take out both hard drives
- Format both drives (e.g., to NTFS)
...
- Attach both hard drives
...
- Start the appliance
- The appliance will be reinitialized and back to the
...
- delivery state
- Configure your appliance from scratch and restore backups if necessary
Related articles
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Page Properties | ||
|---|---|---|
| ||
|
...